The Anatomy of Bridgework. William Henry Thorpe

matters relating to open-web girders will be more conveniently dealt with under their separate headings, particularly a further consideration of the relationship subsisting between the booms and floor structure.

CHAPTER III.

       BRIDGE FLOORS.

       Table of Contents

      The floors of bridges commonly give more trouble in maintenance, and their defects are more frequently the cause which renders reconstruction necessary, apart from reasons not concerning strength, than any other part of such structures. When it is considered that this portion of a bridge is first affected by impact of the load which comes upon it, and is usually light in comparison with the main girders further removed from the load, and to which the latter is transferred through the more or less elastic floor, the fact will be readily appreciated by those not already familiar with it.

      The end attachments of cross and longitudinal girders are very liable to suffer by loosening of rivets, or, more rarely, by breaking of the angle-irons which commonly make such a connection. A not unusual defect of old work, which may also sometimes be seen in work quite new, where the cross-girder depth has from any cause been restricted, is the extremely cramped position of the rivets securing the ends. There is small chance of these ever being properly tight, if the act of riveting is rendered difficult by bad design. This is the more objectionable if it happens that cross-girder ends abut against opposite sides of the web of an intermediate main girder, and are secured by the same rivets passing through. At the best such rivets will not be well placed to insure good workmanship, and the severe treatment to which they become subject, as the cross-girders take their load and deflect under it, will be very apt to loosen them. The author has seen a case of this kind (see Figs. 11 and 12)—rather extreme, it is true—in which nearly the whole of the cross-girder end rivets were loose, some nearly worn through, thus allowing the cross-girders to be carried, not by their attachments, but by resting upon the main-girder flanges, which in turn, by repeated twisting, tore the web for a length of 4 feet; there was also pronounced side flexure of the top booms. The movements generally on this bridge (of 42-feet span), whether of main or cross-girders, were very considerable and disturbing. It was removed after about twenty-three years’ use.