Global Drought and Flood. Группа авторов

Spectroradiometer (MODIS) on NASA’s Terra and Aqua satellites and the Visible Infrared Imaging Radiometer Suite (VIIRS) of the Suomi National Polar‐orbiting Partnership (NPP). (a) The drought in New England that put crops and businesses under stress. (b) The drought that reduced food production and increased famine in the Greater Horn of Africa.

      (Courtesy: NASA’s earth observatory: https://earthobservatory.nasa.gov/images)

      Van Loon and Van Lanen (2012) described different scenarios of snow related drought according to their development: (a) rain‐to‐snow season drought, (b) cold snow season drought, and (c) warm snow season drought. Rain‐to‐snow season drought is developed due to a shortage of rainfall in the rain season (spring, summer and/or autumn) and ends in snow season (winter) with precipitation being in the form of snow. Consequently, soil moisture, streamflow, and groundwater remain relatively low until the upcoming melt season. Cold snow season drought is a result of abnormally low temperature in the snow season and a possible coincidence with below‐average precipitation that can be categorized into three subtypes of A, B, and C. Subtype A describes climates with continuous snow cover during winter and below zero temperature. Early beginning of the snow season is the main driver of this drought type. Subtype B has the same climate as A, however, delay in snowmelt due to low temperature at the end of winter drives this type of snow drought. Subtype C is climate with a temperature around zero and limited snow accumulation in winter. Snowmelt often provides recharge to groundwater and streamflow during snow season. An abnormal temperature drop in winter results in an intermediate shortage of water for a few weeks to months duration.

      Harpold et al. (2017) divided snow drought into two categories: (a) warm snow drought, where accumulated precipitation during October–March is larger than the long‐term average and SWE on 1st April is less than the long‐term average; (b) dry snow drought, where accumulated precipitation for the same period is less than the long‐term average and SWE on 1st April is less than the long‐term average SWE.

In addition to the conceptual definition of snow drought, operational systems require relevant indicators to monitor snow drought. These indicators should provide insight on frequency, severity, and duration of snow drought and help to develop prevention and mitigation strategies (Paneque, 2015). Indices such as SPI or PDSI are widely used to characterize hydrological droughts, however, these indices do not explicitly account for the effects of snow on water availability in snow‐dominated watersheds (Mote et al., 2016). Staudinger et al. (2014) proposed a drought index that would account for snow. This new index, termed Standardized Snow Melt and Rain Index (SMRI), is calculated similar to the SPI but uses summation of snowmelt and rain as input. The authors proposed an algorithm based on temperature threshold that does not require snow data and utilizes temperature and precipitation to model snow. It should be noted that the output of any snow model could be used to calculate the index. Knowles et al. (2017) developed a snow aridity index (SAI) to assess ecosystem disturbance based on a long history of snow remote sensing. The SAI is defined as a ratio of the sum of 1st April to 31st August PET to maximum SWE (PET/SWE; Figure 1.8). It can be argued that SAI is a suitable index for characterizing snow drought since it uses both potential evapotranspiration and SWE (Knowles et al., 2017, 2018).

      Snowpack is often characterized in terms of snow albedo (SA), snow depth (SD), SWE, DPS, snow covered area (SCA), and fractional snow‐covered area (fSCA) (Kongoli et al., 2012). Remote sensing can effectively describe the relationship between snowpack dynamics and climate variability (Guan et al., 2012). Using remote sensing techniques and retrieval algorithms to measure snow‐related variables may provide insight for real‐time snow drought monitoring. The following provides a very short review of different remote sensing data and products that can be used to characterize snowpack.

      Snow possesses a strong spectral gradient that ranges from high albedo in visible wavelengths to low reflectance in middle infrared wavelengths. Therefore, a commonly used method such as the band ratios can be utilized to map and monitor snow cover (Lettenmaier et al., 2015). The Normalized Difference Snow Index (NDSI) is one that shows the presence of snow on the ground. The NDSI algorithm distinguishes between snow and most cloud types, therefore, it better characterizes the snow cover areas than fSCA. The NDSI utilizes the reflectance ratios to detect snow and is described as the normalized difference between green and SWIR reflectance (R _Green− R _SWIR2)/(R _Green + R _SWIR2) (Hall et al., 2002). Hatchett and McEvoy (2018) suggested using NDSI in conjunction with data from ground‐based observation networks to monitor snow drought. In forested regions, however, the NDSI has shown poor snow identification accuracy and the recently developed Normalized Difference Forest Snow Index (NDFSI) can produce higher identification accuracy. The NDFSI utilizes near‐infrared in place of the green band, which has a higher reflectance that is useful when there is snow in a forested area (X. Y. Wang et al., 2015).

Several satellites are capable of detecting fSCA, such as the AVHRR, MODIS, and Landsat. However, a common issue with AVHRR is the inadequacy of its 1 km spatial resolution for snow mapping on small catchments (Simpson et al., 1998; H. Xu et al., 1993). Rott et al. (2010) suggested that the Cold Regions Hydrology High‐Resolution Observatory (CoReH2O) from the ESA would deliver accurate and spatially detailed observations of snow mass. MODIS and Landsat Thematic Mapper (TM) alleviate this shortcoming to some extent by offering observations with a spatial resolution of 250 m and 30 m, respectively (Hall et al., 2002). A major concern regarding the optical‐based satellites, however, is the discontinuity of observations due to the presence of clouds. Clouds hinder the spatiotemporal consistency of snow cover due to having similar reflectance properties to snow in a wide range of the electromagnetic spectrum (Aghakouchak, Farahmand, et al., 2015). On the other hand, microwave measurements can be used to estimate fSCA and SD even in the presence of clouds, since they do not depend on sunlight reflection. Similar to optical‐based satellites, the microwave observations become flawed once SD exceeds 30 cm and in melting conditions (Foster et al., 1997; Walker & Goodison, 1993). Therefore, more accurate and consistent measurements of SD retrievals can be achieved through an integrated framework by combining observations from both types of satellites (Durand et al., 2008; Foster et al., 2011). In an effort to simulate the spatiotemporal distribution of SWE in mountainous regions, the NASA Jet Propulsion Laboratory (JPL) Airborne Snow Observatory (ASO) provides near‐weekly lidar surveys. The derived SDs obtained from lidar scanners are then assimilated into hydrological models to produce higher temporal resolution of SWE distribution and volume. Recently, Hedrick et al. (2018) combined the iSnobal physically based distributed snowmelt model with ASO and produced daily SWE images with spatial resolution of 50 m.

Figure 1.8 A below‐normal snowpack observed by the Moderate Resolution Imaging Spectroradiometer (MODIS) on NASA’s Terra satellite. (a) Percent of fractional snow cover on 25 January 2016. (b) Below normal conditions in 29 January 2018.

      (Courtesy of NASA’s earth observatory: https://earthobservatory.nasa.gov/images)

      Snow water equivalent is a critical parameter for hydrological applications and the characterization of snowpacks, and is commonly estimated using passive microwave signals utilizing empirical relationships or radiative transfer models. Well‐known limitations of spaceborne passive microwave data, such as coarse spatial resolution, saturation in deep snowpack, and signal loss in wet snow, however, present major drawbacks for passive microwave retrieval algorithms. Brodzik et al. (2016) developed high‐resolution passive microwave brightness temperature data that can be used to improve the SWE estimate in mountainous regions with complex physiography.

      Peak SWE is an important variable in snow hydrology, traditionally,