CompTIA A+ Practice Tests. Docter Quentin

mercury. Current is run through the gas to ionize it and cause it to light up.

29

B. The audio connector on the front or top panel will use a round, 3.5mm connector. You can plug speakers or headphones into it.

30

D. With most dual-channel motherboards, RAM will work just fine if one module is installed. However, you will get better performance if you fill the entire bank.

31

D. There are four major versions of PCIe currently specified: 1.x, 2.x, 3.0, and 4.0. For the four versions, a single omnidirectional lane operates at a data rate of 250MBps, 500MBps, approximately 1GBps, and roughly 2GBps, respectively.

32

A, D. When installing or replacing a power supply, always make sure that it has enough wattage to power the components in the computer. In addition, it should have enough connectors to connect to all the components that require their own power. Dual rail and dual voltage are optional features.

33

D. Double-sided memory has chips on both sides of the RAM module instead of just on one side. It allows for doubling the amount of RAM on the module, so you get twice as much memory on one stick.

34

A, B. Faster hard drives transfer more data than slower hard drives, but there is no specific correlation between hard drive speed and its lifespan. The downsides to faster hard drives can be increased battery usage and heat production.

35

A, B. PCI expansion buses operate at 33MHz or 66MHz (version 2.1) over a 32-bit (4-byte) channel, resulting in data rates of 133MBps and 266MBps, respectively, with 133MBps being the most common, server architectures excluded.

36

C. Print servers need to have the appropriate drivers for all operating systems that will be clients. It’s possible that this print server does not have the Mac driver installed.

37

D. A privacy filter is a panel that fits over the front of a display and, through a polarization affect, intentionally limits the viewing angle of the monitor.

38

B. The connector shown is USB Type B. It will plug into the USB peripheral device and is commonly used by printers.

39

B. Most digital monitors have a native resolution, which is a single, fixed resolution that they support. Attempting to change the resolution may result in distorted images, or the image may not display at all.

40

B, C. Liquid cooling systems are generally quieter than air-based systems that use fans, and they are more efficient at cooling the processor. However, they are more complex to install, and if the liquid were to leak out, that could cause damage to internal components.

41

C, D. Impact printers create images by impacting the paper, which can wear down the print head. Always check that. Also, impact printers most often use tractor feed mechanisms to load the paper, and they can wear down as well.

42

C. PCIe uses lanes. Each lane between any two intercommunicating devices comprises a separate pair of wires for both directions of traffic, which dramatically increases speed.

43

A. A thin client is any machine that divests itself of all or most local storage and varying levels of RAM and processing power without necessarily giving up all ability to process instructions and data.

44

C. The reset button, usually located on the front or top panel, allows a user to reboot the computer from a cold startup point without removing power from the components. This can be particularly helpful for dealing with software lockups.

45

B. The two most popular methods of manufacturing LCD panels are twisted nematic (TN) and in-plane switching (IPS). Of the two, IPS is regarded as having the best color representation in all angles, while TN is faster and less expensive. LED and plasma are not types of LCD panels.

46

B, C. A home server PC should be able to handle media streaming, as well as file and printer sharing. A dedicated print server is not likely needed, though, as the operating system can function as a print server. A gigabit NIC will be helpful to manage the network traffic, and a RAID array can help protect against hard drive failure.

47

B. The x8 card won’t completely fill the x16 slot, but it will work at x8 speeds of up- plugging is supported by the motherboard. Otherwise, the specification requires up-plugged devices to operate at only the x1 rate.

48

B. Secure Boot is an option enabled in system firmware. BIOS is not technically advanced enough to manage Secure Boot, but its successor UEFI is.

49

A. DDR has 184 pins, DDR2 and DDR 3 have 240 pins, and SODIMMs can have 72, 100, 144, 200, or 204 pins.

50

D. Hyperthreading-capable processors appear to the operating system to be two processors. As a result, the operating system can schedule two processes at the same time on the same physical core.

51

A. Dot-matrix printers are impact printers and typically require paper that always feeds at a consistent rate. To achieve this, the paper will have holes on the outside edges, which is fed into the printer using a tractor feed mechanism.

52

D. Embedded MultiMediaCard (eMMC) can be permanently embedded on the circuit board of a cheaper or smaller mobile device. All of the other flash memory standards, such as CompactFlash, xD, miniMMC, and microMMC are designed to be removable.

53

A. ATX motherboards are common in desktop computers and measure 12″ × 9.6″. They are the largest motherboards commonly used in personal computers today.

54

C. The motor that makes the print head carriage move is also often called the carriage motor or carriage stepper motor. It has a belt attached to it, the carriage belt, which moves the print head carriage back and forth.

55

A, D. For an audio/video editing workstation, you should maximize the audio and video capabilities, including having at least two large monitors. Videos also take a lot of disk space, so significant storage space is required.

56

A, D. Intel’s Virtualization Technology (Intel VT) is needed to support virtualization. It’s enabled in the BIOS, not the operating system.

57

A. Graphic design (or CAD/CAM) workstations require solid CPU power, RAM, and a high-end video card. Hard drive storage is the least important upgrade for these types of users.

58

C. The most common analog video connector is a VGA connector.

59

A. Refresh rate defines the vertical scan frequency of a monitor and determines how many times, in one second, an image can be redrawn on the screen. Many LCD monitors have a fixed refresh rate.

60

D. Thunderbolt v1 and v2 both provide 20Gbps of data bandwidth. In addition, Thunderbolt ports power the attached peripherals with 18V and 9.9W of power.

61

B. The fuser heats up to approximately 350° Fahrenheit. Do not touch it as it will cause burns!

62

B. A standard thick client is not really a custom configuration; it’s the standard configuration on which custom configurations are based. In other words, a thick client is a standard client computer system.

63

C. The order of steps is processing, charging, exposing, developing, transferring, fusing, and cleaning.

64

B, C. PCI slots and adapters are manufactured in 3.3V and 5V versions. Adapters are keyed to fit in a slot based on their voltage requirements. Universal adapters are keyed to fit in slots based on either of the two voltages.

65

A. Trusted Platform Module (TPM) is an international standard for a dedicated security coprocessor, or cryptoprocessor. Coupled with a BIOS, it can be configured to boot the system only after authenticating the boot device.

66

A. The transfer corona assembly is given a high-voltage charge, which is transferred to the paper, which in turn pulls the toner